
双组份打胶机压力不足的解决措施?
时间:2020-04-09 来源:http://www.jncsjx.com/ 发布人:昌盛机械
中空玻璃胶机除了丁涂层机、双组分胶机,在很长一段时间的使用和选择的一般配置情况下,会出现感觉手的压力是不够的,那么,是什么导致了它,我们应该如何解决这个问题?
In addition to the butyl coating machine and the two-component glue machine, the pressure of the hand is not enough under the long-term use and selection of the general configuration of the insulating glass glue machine. Then, what causes it and how should we solve this problem?
橡胶混合问题
Rubber mixing problem
当我们混合的时候,我们用手混合,直接暴露在空气中。
When we mix, we mix by hand, and we're exposed directly to the air.
第二中空玻璃橡胶厂生产问题
Production problems of the second insulating glass rubber factory
双组分上胶机自动混合后,上胶机自动混合后的这种情况,是厂家没有按照严格的工艺流程将部件中的空气去除造成的。
After the automatic mixing of the two-component gluing machine and the automatic mixing of the gluing machine, the manufacturer did not remove the air in the parts according to the strict process flow.

那么如何解决这些问题呢?
So how to solve these problems?
1 .液压站压力不稳定,将混合芯轴清洗试试
1. The pressure of the hydraulic station is not stable. Clean the mixed mandrel
2. 搅拌不均匀主要是由于u型管内的粘接剂凝固,需要定期清洗。
2. The uneven mixing is mainly due to the solidification of the adhesive in the U-shaped pipe, which needs to be cleaned regularly.
以上就是对双组份打胶机压力不足的解决措施的详细介绍,想要了解更多请点击官网http://www.jncsjx.com
The above is a detailed introduction of the solutions to the pressure shortage of the two-component dispenser. For more information, please click http://www.jncsjx.com
- 折弯先看回弹量 2026/11/16
- 封胶线先看转角 2026/11/14
- 灌分子筛的隐形时钟 2026/11/12
- 一条线跑顺,先别只盯“全自动”三个字 2026/11/09
- 涂得准却压不上,卡在工序接缝那几秒 2026/11/06
- 胶条断在第三边,锅不一定在机器 2026/11/04
- 0.5毫米的偏差,整窗质保直接归零 2026/11/02
- 别看参数表,先看今天车间里堆的是哪种框 2026/10/30
- 中空玻璃漏不漏气,第一道胶就定了生死 2026/10/28
- 中空玻璃起雾,八成是第一道胶没涂稳 2026/10/26

当前位置:



产品分类Product categories
联系我们Contact us
