1.由于双组份密封胶的固化需要一定时间，因此双组份打胶机，已涂了双组份密封胶的玻璃应水平轻轻搬动。

　　1., since the curing of two component sealants takes a certain time, the two component glue machine has been coated with two components of sealant glass and should be moved gently.

　　2.A组、B组份胶应保持清洁，严防异物进入胶中。

　　Group 2.A and B components should be kept clean, and foreign matters should be strictly prevented from entering the glue.

　　3.在连续工作过程中，胶枪每次停止工作时间一般不得超过20分钟，否则，应用A组份胶冲出全部混合胶，直至单一的A组份胶从枪口排出为止。

　　3. in the continuous working process, the glue gun will not stop working more than 20 minutes each time. Otherwise, all the mixed glue is washed out with A component glue until the single A component is discharged from the muzzle.

　　4.高压胶管不得强行挤压、弯曲，防止影响系统正常工作。

　　4., high pressure hose should not be forced to bend or bend to prevent the system from functioning normally.

　　5.混胶器应经常保持畅通，以保证良好的出胶效果。如遇堵塞情况，可用丙酮浸泡后清洗。建议每5组清洗一次。

　　5., rubber mixer should be kept regular and smooth, so as to ensure good glue production. In case of clogging, acetone can be soaked and cleaned. It is suggested that every 5 groups be cleaned once.

　　6.当胶枪长时间不用时(超过一周)，应拆下枪体使用溶剂将胶枪和混胶器内的残留胶体清洗干净。

　　6., when the glue gun is not used for a long time (more than a week), the gun body should be removed and the residual colloid in the glue gun and glue mixing machine should be cleaned with solvents.

　　7.不同双组份胶生产厂家所生产的胶内含杂质数量不同，根据实际情况清晰B组分的过滤网及单向止回阀，建议每两组清洗一次.

　　7. the number of impurities in the rubber produced by the different double component rubber manufacturers is different. According to the actual situation, the filter net and the one-way check valve of the B component are clear. It is suggested that every two groups be cleaned once.

　　本文由双组份打胶机为您提供，我们的网站是:http://www.jncsjx.com我们将以全心全意的热情为您提供更优质的服务，欢迎您的访问!

　　This article is provided by the double component glue machine for you. Our website is: http://www.jncsjx.com we will provide you with more quality service and welcome your visit with wholehearted enthusiasm.