中空玻璃由两层或多层平板玻璃组成。中空玻璃机用高强度、高气密性复合粘结剂将两个或多个玻璃与密封条和玻璃条粘接密封。中间充入干燥气体，框架内充入干燥剂，保证玻璃片之间空气的干燥度。可根据需要选择不同性能的玻璃原片，如无色透明浮法玻璃压花玻璃、吸热玻璃、热反射玻璃、夹丝玻璃、钢化玻璃等。并与框架(铝框架或玻璃条等)粘结、焊接或熔接而成。目前国内市场上中空玻璃只有两种，槽铝中空玻璃和胶条中空玻璃。由此一般用中空玻璃设备，来操作。
Insulating glass consists of two or more layers of flat glass. The insulating glass machine uses high-strength, high air tightness composite adhesive to bond and seal two or more glasses with the sealing strip and the glass strip. Dry gas is filled in the middle and desiccant is filled in the frame to ensure the dryness of the air between the glass sheets. You can select glass sheets with different properties according to your needs, such as colorless transparent float glass, embossed glass, heat absorbing glass, heat reflecting glass, wired glass, tempered glass, etc. It is bonded, welded or welded with the frame (aluminum frame or glass strip, etc.). At present, there are only two kinds of insulating glass in the domestic market, i.e. channel aluminum insulating glass and adhesive strip insulating glass. Therefore, insulating glass equipment is generally used for operation.
用中空玻璃设备用途，玻璃切割是如果下料的
Use of insulating glass equipment. If the glass is cut
原玻璃一般为无色浮法玻璃或其他彩色玻璃，遮阳玻璃、钢化玻璃、夹层玻璃，厚度一般为3-12MM，上述玻璃符合GB11614中、优等品的要求，经检验合格后方可使用。玻璃切割可以手动或机器进行，但应符合尺寸要求。在操作过程中，工人应随时注意玻璃表面不得划伤，内质均匀，不得有气泡、夹渣等明显缺陷；
The original glass is generally colorless float glass or other colored glass, sun shading glass, tempered glass and laminated glass, with a thickness of 3-12mm. The above glass meets the requirements of gb11614 for medium and high-quality products, and can be used only after passing the inspection. Glass cutting can be carried out manually or by machine, but shall meet the dimensional requirements. During operation, workers should always pay attention that the glass surface should not be scratched, the inner quality should be uniform, and there should be no obvious defects such as bubbles and slag inclusions;
玻璃清洗干燥：
Glass cleaning and drying:
玻璃清洗采用机器清洗，因为人工清洗不能保证清洗质量。清洗前应检查玻璃无划痕。为了保证密封胶与玻璃的附着力，使用去离子水。此外，为了保证水的循环利用，节约水资源，可以过滤水，保证长期使用。清洗后的玻璃应通过光照检查，检查玻璃表面是否有水滴、水渍等污渍。如果有水滴、水渍等污渍，需要调整机器的运行速度、加热温度、风量和刷子间隙，直到效果完好。清洗后的玻璃应在1小时内组装成中空玻璃。另外，要保证玻璃之间不会有摩擦和划伤。有半成品玻璃储存车，将玻璃片与片子隔开；
Machine cleaning is adopted for glass cleaning, because manual cleaning cannot guarantee the cleaning quality. Check whether the glass is free of scratches before cleaning. To ensure the adhesion between sealant and glass, use deionized water. In addition, in order to ensure the recycling of water and save water resources, water can be filtered to ensure long-term use. The cleaned glass shall be inspected by light to check whether there are water drops, water stains and other stains on the glass surface. If there are water drops, water stains and other stains, it is necessary to adjust the running speed, heating temperature, air volume and brush clearance of the machine until the effect is intact. The cleaned glass shall be assembled into hollow glass within 1 hour. In addition, ensure that there is no friction and scratch between the glasses. There are semi-finished glass storage vehicles to separate glass sheets from each other;
以上就是为大家介绍的全自动封胶线http://www.jncsjx.com的详细的介绍,希望对您有所帮助.如果您有什么疑问的话,欢迎联系我们.我们将以的态度,为您提供服务.
The above is the fully automatic sealing line introduced for you http://www.jncsjx.com I hope it will be helpful to you If you have any questions, please contact us We will provide you with professional service