中空玻璃开胶了，您可以按照以下步骤进行处理：

　　The insulating glass has opened, you can follow the following steps to handle it:

　　卸下玻璃 ：

　　Remove the glass:

　　如果是打胶的，使用美工刀将四周的胶刮掉。

　　If it is adhesive, use a craft knife to scrape off the adhesive around.

　　如果使用皮条，则将皮条取下。

　　If using leather straps, remove them.

　　然后轻轻掰下玻璃压线，取下玻璃。

　　Then gently break off the glass pressure line and remove the glass.

　　清理玻璃四周 ：

　　Clean the surroundings of the glass:

　　刮除玻璃四周的残余胶。

　　Scrape off the residual adhesive around the glass.

　　使用酒精清洗，然后用干净的抹布擦干净。

　　Clean with alcohol and then wipe clean with a clean cloth.

　　重新合片 ：

　　Re film:

　　清洁干净后，重新将玻璃合片。

　　After cleaning thoroughly, reassemble the glass.

　　使用铝格条（位于玻璃中间）进行合片。

　　Use aluminum grid strips (located in the middle of the glass) for lamination.

　　合片时确保四周打胶均匀严实，避免漏气漏水。

　　Ensure that the adhesive is evenly and tightly applied around the edges during lamination to avoid air and water leakage.

　　干燥与安装 ：

　　Drying and installation:

　　合片后放置一天，让胶水完全干燥，建议1-2天。

　　After laminating, let the adhesive dry completely for one day, recommended 1-2 days.

　　干燥后，将玻璃重新安装到窗框上。

　　After drying, reinstall the glass onto the window frame.

　　使用玻璃胶或皮条进行四周密封。

　　Use glass glue or leather tape to seal around.

　　请注意，如果中空玻璃出现裂纹或脱胶，不仅会影响其隔音隔热效果，还可能存在安全隐患，此时应考虑更换玻璃。如果不确定问题原因，建议联系专业人员进行检查和维修

　　Please note that if there are cracks or delamination in the insulated glass, it will not only affect its sound insulation effect, but may also pose a safety hazard. In this case, replacement of the glass should be considered. If the cause of the problem is uncertain, it is recommended to contact professionals for inspection and repair

　　本文由中空玻璃加工设备提供帮助，更多的相关内容请点击：http://www.jncsjx.com希望本文能够为您带来帮助，感谢您的阅读！

　　This article is assisted by insulating glass processing equipment. For more related content, please click: http://www.jncsjx.com I hope this article can be helpful to you. Thank you for reading!