中空玻璃打胶机操作与控制对于刚刚购买打胶机的玻璃厂来说非常重要，下面说一下怎么使用和控制。
The operation and control of insulating glass gluing machine is very important for the glass factory that just bought the gluing machine. Let's talk about how to use and control it.
操作流程：
Operation process:
1、放在一个平整干净的平面上，连接电源和气源，两者确认接通之后就开始进行操作。
1. Put it on a flat and clean surface, connect the power supply and air source, and start the operation after they are confirmed to be connected.

2、打胶机中间会有一个混胶过程，在供胶机上面混胶完毕之后，需要在电子显示屏上控制面板上进行选择“行走设置”。打开界面之后按T1键前进行走。在机头停止时，打开机头上面B胶阀门，接着在控制面板上找到Esc键返回主界面，然后F2状态设置，在打开界面后按K3键供胶开始，当胶嘴中完全混合的胶流出按K4键结束供胶。
2. There will be a glue mixing process in the middle of the glue feeder. After mixing the glue on the glue feeder, you need to select "walking setting" on the control panel on the electronic display screen. After opening the interface, press T1 to move forward. When the machine head stops, open the B glue valve on the machine head, then find the ESC key on the control panel to return to the main interface, and then set the F2 status. After opening the interface, press the K3 key to start the glue supply. When the glue completely mixed in the glue mouth flows out, press the K4 key to end the glue supply.
3、需要记住的是工作结束之后或者在较长时间不工作时，需要冲洗混胶装置，防止供胶管的堵塞，影响未来使用效果。
3. It should be remembered that after the work or when it is not working for a long time, the glue mixing device needs to be flushed to prevent the blockage of the rubber supply pipe from affecting the future use effect.
4、调整环节：吸盘调整：涂胶机吸盘与旋转台的高度调整合适。
4. Adjustment link: suction cup adjustment: the height of the suction cup of the gluing machine and the rotating table shall be adjusted properly.
5、气动开关、胶嘴、探针调整：将事先合好的中空玻璃放在旋转台上，靠近涂胶机工作面，然后中空玻璃推到定位上，调整胶嘴与玻璃的高度，使出胶嘴的出胶口中心语铝槽中心在同一个水平线上：胶嘴与玻璃之间的顶力合适：铝槽深度检测探针与出胶口中心线在统一水平线上。
5. Adjustment of pneumatic switch, rubber nozzle and probe: put the pre closed insulating glass on the rotary table close to the working surface of the gluing machine, and then push the insulating glass to the positioning to adjust the height between the rubber nozzle and the glass, Make the center of the glue outlet of the glue nozzle and the center of the aluminum groove on the same horizontal line: the jacking force between the glue nozzle and the glass is appropriate; the aluminum groove depth detection probe and the center line of the glue outlet are on the same horizontal line.