在使用封胶机时要注意哪些事项：
What should be paid attention to when using the sealing machine:
1.混合胶在胶枪内滞留时间一定要控制在3-5分钟内，否则蜂鸣器报警。
1. The retention time of mixed glue in the glue gun must be controlled within 3-5 minutes, otherwise the buzzer will give an alarm.
2.封胶之前要检查双组份胶的混合化，将胶挤到100mm的正方形，厚3mm的浮法玻璃上，再那一块同样的浮法玻璃在玻璃上一压，在光亮处检查，如混合胶内有白丝或黑丝，即混合不均匀。
2. Before sealing the glue, check the mixing of the two-component glue, squeeze the glue onto the 100mm square and 3mm thick float glass, press the same float glass on the glass, and check at the bright place. If there are white or black wires in the mixed glue, the mixing is uneven.

3.要时刻注意液压设备压力表（指针指在绿色没有问题，黄色、红色危险）。
3. Always pay attention to the pressure gauge of hydraulic equipment (the pointer indicates that there is no problem in green, and yellow and red are dangerous).
4.注意胶筒压力表（A组份胶6bar,B组份胶4bar）。
4. Pay attention to the rubber cylinder pressure gauge (6bar for component A and 4bar for component B).
工作完毕后，关闭设备，打开胶枪，将胶枪内的胶全部挤出压力小于30bar，如长时间不用，先将Operatingmade(操作模式开关)打至BASEPURGE(基料冲洗)，再打开胶枪，直至A组份胶全部挤出，设备关闭，继续打胶直至压力小于30bar后放入冷冻箱。
After the work is completed, turn off the equipment, turn on the glue gun, and extrude all the glue in the glue gun with the pressure less than 30bar. If it is not used for a long time, first turn the operatingmode switch to BasePage (base material flushing), and then turn on the glue gun until all the glue of component A is extruded, turn off the equipment, continue to glue until the pressure is less than 30bar, and then put it into the freezer.
以上就是今天带给大家的知识，全自动封胶机专注行业多年，为用户不断的提供有价值的内容，更多内容请继续关注我们：http://www.jncsjx.com
The above is the knowledge brought to you today. The automatic sealing machine has focused on the industry for many years and continuously provides users with valuable content. Please continue to pay attention to us for more content: http://www.jncsjx.com