全自动铝条折弯机折弯角度偏差的解决方法可归纳为以下四点，需结合设备检查与参数调整：

　　The solution to the bending angle deviation of the fully automatic aluminum strip bending machine can be summarized into the following four points, which need to be combined with equipment inspection and parameter adjustment:

　　检查模具磨损与安装精度

　　Check mold wear and installation accuracy

　　模具长期使用可能磨损，需定期检查并更换损坏部件。

　　The mold may wear out after long-term use and requires regular inspection and replacement of damaged parts.

　　确保模具安装水平，避免因倾斜导致折弯角度偏差。

　　Ensure that the mold is installed horizontally to avoid bending angle deviation caused by tilting.

　　调整液压系统压力与平衡机构

　　Adjust the hydraulic system pressure and balance mechanism

　　检查液压系统是否正常工作，压力油是否均匀进入左右油缸。

　　Check if the hydraulic system is working properly and if the pressure oil is evenly flowing into the left and right cylinders.

　　若使用电液伺服系统，需观察光栅尺显示的下行深度变化。

　　If using an electro-hydraulic servo system, it is necessary to observe the downward depth change displayed on the grating ruler.

　　校准工作中心与补偿参数

　　Calibration work center and compensation parameters

　　通过测量板材两端误差调整角度补偿，中间误差则通过挠度补偿修正。

　　Adjust the angle compensation by measuring the error at both ends of the board, and correct the intermediate error through deflection compensation.

　　确保滑块与工作台平行度符合标准要求。

　　Ensure that the parallelism between the slider and the workbench meets the standard requirements.

　　检查同步机构与连杆连接

　　Check the connection between the synchronization mechanism and the connecting rod

　　若折弯角度不一致，需检查连杆是否脱开或连接处打滑。

　　If the bending angle is not consistent, it is necessary to check whether the connecting rod is detached or if the connection is slipping.

　　对于大角度折弯（≥90°），可使用角度尺辅助测量并微调连杆位置。

　　For large angle bending (≥ 90 °), an angle ruler can be used to assist in measuring and fine-tuning the position of the connecting rod.

　　操作建议 ：优先通过系统参数调整（如挠度/角度补偿）快速修正，若问题持续则需拆解检查机械部件（如同步机构、液压系统）。若调整无效，建议联系厂家保修服务。

　　Operation suggestion: Prioritize quick correction through system parameter adjustment (such as deflection/angle compensation). If the problem persists, disassemble and inspect mechanical components (such as synchronization mechanisms and hydraulic systems). If the adjustment is ineffective, it is recommended to contact the manufacturer's warranty service.

　　本文由 全自动铝条折弯机  友情奉献.更多有关的知识请点击  http://www.jncsjx.com/   真诚的态度.为您提供为全面的服务.更多有关的知识我们将会陆续向大家奉献.敬请期待.

　　This article is a friendly contribution from the fully automatic aluminum strip bending machine For more related knowledge, please click http://www.jncsjx.com/ Sincere attitude To provide you with comprehensive services We will gradually contribute more relevant knowledge to everyone Coming soon.