1. Preparation: prepare the aluminum spacer strip to be coated, and check whether the parameters of the coating machine are normal.

2. 调整设备：根据需要调整涂布机的涂布速度、压力和温度等参数，确保涂布质量符合要求。

2. Adjusting equipment: Adjust the coating speed, pressure, and temperature parameters of the coating machine as needed to ensure that the coating quality meets the requirements.

3. 丁基胶涂布机在常温下呈固体形态，须经过110-150℃得高温才能融化使用，因丁基胶导热较慢须加热20-30分钟（视气温而定）才能完全融化，所以要求每次使用该机之前要加热胶缸、胶头（110-150℃下保温）待胶融化后才能进行工作 。

3. The butyl adhesive coating machine is in a solid form at room temperature and must undergo a high temperature of 110-150 ℃ before melting. Due to the slow thermal conductivity of the butyl adhesive, it needs to be heated for 20-30 minutes (depending on the temperature) to fully melt. Therefore, it is required to heat the rubber cylinder and head (insulated at 110-150 ℃) before each use of the machine before starting work.

4. 监控涂布质量：丁基胶绝对不能出现断胶，铝条露白，这是影响中空玻璃寿命的关健。确保涂布的均匀性和厚度符合要求。

4. Monitoring the coating quality: The butyl adhesive must not break or the aluminum strip is exposed, which is a key factor affecting the lifespan of the insulating glass. Ensure that the uniformity and thickness of the coating meet the requirements.

5. 完成涂布：涂布完成后，关闭涂布机的开关，清理涂布机的残留物和废料，保持涂布机的清洁。

5. Complete coating: After the coating is completed, turn off the switch of the coating machine, clean the residue and waste of the coating machine, and maintain the cleanliness of the coating machine.